S treatment with proteinase K, Tween, and EDTA, after which the

S treatment with proteinase K, Tween, and EDTA, after which the lysate is used in PCR analyses, either directly [11] or following a clean-up step [13]. In several studies, salivary bacteria were disrupted mechanically using glass, zirconia,or zirconia/silica beads in the presence or absence of phenol, and DNA was purified using different procedures [1,9,10,12]. Here we evaluated two DNA extraction protocols for human saliva samples. DNA extracts obtained by enzymatic or mechanical cell lysis were used to assess bacterial community diversity based on 16S rDNA amplicon pyrosequencing.Materials and Methods Ethics StatementThis study was approved by the Ethics Committee of the Geneva University Hospitals (09?78). Written informed consent was obtained from the participant.Sample 24195657 CollectionUnstimulated human saliva was obtained as described previously [13] from a 32-year old female non-smoker, without obvious signs of oral disease.DNA ExtractionAfter KDM5A-IN-1 ML240 site vigorous mixing by vortex, the saliva sample was divided into six aliquots. Three 100-mL aliquots were mixed with the same volume of 26 lysis buffer (20 mM Tris, 2 mM EDTA pH8, 1 Tween, and 400 mg/mL proteinase K; Fermentas) and then incubated at 55uC for 2.5 h, followed by heating at 95uC forDNA Extraction from Salivary Microbiota10 min to inactivate the proteinase K. Three 200-mL saliva sample aliquots were mixed with 700 mL of lysis buffer SL1 (SDScontaining) and 120 mL of Enhancer SX from the NucleoSpin Soil Kit (Macherey-Nagel). The mixture was shaken in a NucleoSpin Bead Tube for 2 min at maximum speed on a Vortex-Genie 2 with a horizontal tube holder (Scientific Industries). From this point, we followed the NucleoSpin Soil Kit protocol (MachereyNagel). DNA was eluted in 100 mL of elution buffer SE. DNA extracts from both protocols were stored at 220uC.PCR and SequencingPCR amplification mixtures included 5 mL of DNA extract, 25 pmol each of forward primer (59-ctatgcgccttgccagcccgctcag-acGAGTTTGATCMTGGCTCAG-39) and a barcoded reverse primer (59-cgtatcgcctccctcgcgccatcag-NNNNNNNN-atCCGCGGCTGCTGGCAC-39) in 50 mL Primestar HS Premix (Takara). The composite PCR primers were designed as described previously [11] except that they contained Titanium adaptor sequences (plain lowercase). For each of the six DNA extractions (three enzymatic and three mechanical), two separate PCRs were carried out using reverse primers with a different barcode. All PCRs were performed in duplicate using the following parameters: 30 cycles of 98uC for 10 s, 56uC for 15 s, and 72uC for 1 min. The V1? amplicons corresponded to bases 28?14 (excluding primer sequences) in the Escherichia coli 16S rRNA gene. Amplicon sizes were checked on a 2100 Bioanalyzer (Agilent). Two replicate PCRs were then pooled and purified using a QIAquick PCR Purification Kit (Qiagen). DNA quantity was assessed using a NanoDrop ND-8000 spectrophotometer (NanoDrop Technologies). Three hundred nanograms of each of the purified samples were then pooled and sequenced from the reverse primer on a Genome Sequencer FLX system with Titanium chemistry (Roche) at LGC Genomics (Berlin, Germany).Real-time PCRTo determine the concentration of bacterial DNA, real-time PCR was carried out on an Mx3005P Stratagene cycler using a Brilliant II SYBR Green QPCR Master Mix Kit (Stratagene). Reaction mixtures contained 1 mL of DNA extract, 7.5 pmol each of forward (59-ACTCCTACGGGAGGCAGCAGT-39) and reverse (59-ATTACCGCGGCTGCTGGC-39) HPLC-purified primers [17] and 0.7.S treatment with proteinase K, Tween, and EDTA, after which the lysate is used in PCR analyses, either directly [11] or following a clean-up step [13]. In several studies, salivary bacteria were disrupted mechanically using glass, zirconia,or zirconia/silica beads in the presence or absence of phenol, and DNA was purified using different procedures [1,9,10,12]. Here we evaluated two DNA extraction protocols for human saliva samples. DNA extracts obtained by enzymatic or mechanical cell lysis were used to assess bacterial community diversity based on 16S rDNA amplicon pyrosequencing.Materials and Methods Ethics StatementThis study was approved by the Ethics Committee of the Geneva University Hospitals (09?78). Written informed consent was obtained from the participant.Sample 24195657 CollectionUnstimulated human saliva was obtained as described previously [13] from a 32-year old female non-smoker, without obvious signs of oral disease.DNA ExtractionAfter vigorous mixing by vortex, the saliva sample was divided into six aliquots. Three 100-mL aliquots were mixed with the same volume of 26 lysis buffer (20 mM Tris, 2 mM EDTA pH8, 1 Tween, and 400 mg/mL proteinase K; Fermentas) and then incubated at 55uC for 2.5 h, followed by heating at 95uC forDNA Extraction from Salivary Microbiota10 min to inactivate the proteinase K. Three 200-mL saliva sample aliquots were mixed with 700 mL of lysis buffer SL1 (SDScontaining) and 120 mL of Enhancer SX from the NucleoSpin Soil Kit (Macherey-Nagel). The mixture was shaken in a NucleoSpin Bead Tube for 2 min at maximum speed on a Vortex-Genie 2 with a horizontal tube holder (Scientific Industries). From this point, we followed the NucleoSpin Soil Kit protocol (MachereyNagel). DNA was eluted in 100 mL of elution buffer SE. DNA extracts from both protocols were stored at 220uC.PCR and SequencingPCR amplification mixtures included 5 mL of DNA extract, 25 pmol each of forward primer (59-ctatgcgccttgccagcccgctcag-acGAGTTTGATCMTGGCTCAG-39) and a barcoded reverse primer (59-cgtatcgcctccctcgcgccatcag-NNNNNNNN-atCCGCGGCTGCTGGCAC-39) in 50 mL Primestar HS Premix (Takara). The composite PCR primers were designed as described previously [11] except that they contained Titanium adaptor sequences (plain lowercase). For each of the six DNA extractions (three enzymatic and three mechanical), two separate PCRs were carried out using reverse primers with a different barcode. All PCRs were performed in duplicate using the following parameters: 30 cycles of 98uC for 10 s, 56uC for 15 s, and 72uC for 1 min. The V1? amplicons corresponded to bases 28?14 (excluding primer sequences) in the Escherichia coli 16S rRNA gene. Amplicon sizes were checked on a 2100 Bioanalyzer (Agilent). Two replicate PCRs were then pooled and purified using a QIAquick PCR Purification Kit (Qiagen). DNA quantity was assessed using a NanoDrop ND-8000 spectrophotometer (NanoDrop Technologies). Three hundred nanograms of each of the purified samples were then pooled and sequenced from the reverse primer on a Genome Sequencer FLX system with Titanium chemistry (Roche) at LGC Genomics (Berlin, Germany).Real-time PCRTo determine the concentration of bacterial DNA, real-time PCR was carried out on an Mx3005P Stratagene cycler using a Brilliant II SYBR Green QPCR Master Mix Kit (Stratagene). Reaction mixtures contained 1 mL of DNA extract, 7.5 pmol each of forward (59-ACTCCTACGGGAGGCAGCAGT-39) and reverse (59-ATTACCGCGGCTGCTGGC-39) HPLC-purified primers [17] and 0.7.